Wavelength-stabilized laser modules are now plug-and-play

Nov. 1, 2001
At Alcatel, engineers have developed a laser that can be mass-produced while still providing customized wavelengths that are stable with temperature. This is achieved by using a single basic laser with an interchangeable external cavity to provide the amplification and set the wavelength. So far, researchers have demonstrated an average output power of 1 mW over four different wavelengths in the C-band, and a modulation speed of 622 Mbit/s. With optimization of the electrical lines, researchers said, the laser should work at 2.5 Gbit/s.1

Standard indium phosphide (InP) lasers are coupled into a lensed fiber. These components are held in a silicon mount that includes a V-groove so that fibers can be aligned passively, and then packaged in an MT-connector. The other half of the system is a fiber Bragg grating that controls the emitted wavelength.

To give the system its stability with temperature, the team used two materials with different thermal-expansion coefficients: as one expands, the other contracts, thus keeping the fiber Bragg wavelength relatively constant. This doesn't work to 100%: the thermal behavior of the two materials does not quite match perfectly (see figure). But the mode-hopping and wavelength changes that result do not significantly add to the overall wavelength variation, which is less than 50 pm.

The Alcatel team showed that the generic InP device could be used to produce a consistent output at 1530, 1537, 1550, and 1560 nm. For all of these, the threshold current was below 9 mA, and the efficiency above 0.11 W/A. In other experiments, researchers were also able to show that, for temperatures from 0°C to 70°C, the transmission penalty compared to the conventional device is just 0.5 dB (over 90 km and at 6.22 Mbit/s) for the four wavelengths.

For more information contact Arnaud Leroy at [email protected].

Sunny Bains

REFERENCE

  1. A. Leroy et al., Elect. Lett. 37 (16) 1012 (Aug. 2, 2001).

Sponsored Recommendations

April 10, 2025
The value of pluggable optics in open-line systems is also becoming more apparent. This webinar describes this trend and explores how such modules can best be employed. Register...
Dec. 9, 2024
As we wind down 2024, Lightwave’s latest on-topic eBook will examine the hot topics for 2025. AI is at the top of the minds of optical industry players supporting...
Jan. 30, 2025
With the ongoing drive to support AI and the need for high-speed data center interconnection, the call for higher-speed 800G optical technology is emerging. Initially focused ...
Oct. 29, 2024
RURAL BROADBAND:AN OPPORTUNITY AND A CHALLENGE The rural broadband market has always been a challenge for service providers. However, the recent COVID-19 pandemic highlighted ...